|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Wed, 6th May 2020 13:30:00 |
|
A new technique for cooling solar panels |
Scientists in Egypt have investigated the effectiveness of using water and a mixture of aluminum oxide and calcium chloride hexahydrate to cool PV modules. Optimal performance was observed with a solution of 75% water, according to the research findings.
Scientists from Egypt's Benha University have proposed an active cooling technique for PV panels based on the use of water and a mixture of aluminum oxide (Al2O3) and phase change material calcium chloride hexahydrate (CaCl2H12O6). Phase change materials (PCMs) – compounds which can store thermal energy and help stabilize temperature – can absorb or release large amounts of 'latent' heat when they go through a change in their physical state, such as during melting and freezing.
The Benha research team applied various mixtures of their active coolants to a 50 W polycrystalline PV panel and compared performance during summer months in Cairo with that of an untreated panel.
The system involved the use of cooling unit, DC pump, valves, water flow meter and connecting pipes. Aluminum channels were fabricated for the water and the Al2O3/PCM mixture. The channels were placed under the two panels, which were south adjusted and oriented 30 degrees from horizontal.
Technique
The PCM mixture was heated to melting point to form a liquid and Al2O3 nanoparticles were added to it in the aluminum channels. "The dispersion of particles in the PCM liquid is done using an agitator bath with four different mass concentrations," the group stated.
The researchers recorded PV current and voltage, front and rear panel surface temperatures, water inlet and outlet temperatures, solar irradiation, ambient air-dry bulb temperature and wind speed.
"Applying the cooling system, whether using water and/or [the] Al2O3/PCM mixture provides a noticeable drop in cell temperature compared with the uncooled [panel]," said the Egyptian team.
The researchers said a mixture of water and the Al2O3/PCM liquid outperformed the use of water alone and the best performance was recorded from 75% water and 25% Al2O3/PCM.
Read original full article
|
| |
|
|
Back to Featured Articles
|
|
|
|
|
|
|
|
|
|
|
|
Energy News
|
|
| |
| |
